Menu
Previous
Next
Copymaster3D Magnetic Build Surface 310 x 310 mm
€17.99
VAT included
Magnetic Build Surfaces from Copymaster3D are high quality, affordable build surfaces that are reliable time and time again. With hundreds of build surfaces out there to choose from, this should be your go to choice.
Highlights:
Perfectly cut to 310 x 310mm to fit a wide variety of 3D Printers
Soft magnetic backing makes prints easy to remove
Quick heat up time compared to glass
Deep pores to aid adhesion
In stock / EU warehouse
Payment
- 30 days return guarantee
- 2 years minimum warranty Â
- Need a customised offer?
- Request Personalised Offer
Magnetic Build Surface 310 x 310 mm
Buy this Copymaster3D Magnetic Build surface as a spare or replacement for your 3D printer. Cut to 310x310mm this will fit a wide variety of 3D Printers Including:
CR-10, CR-10S, Anet E10, Anet ET5. Artillery Sidewinder X1 and X2. You will get the print surface (Sheet A) and the bottom magnetic layer (Sheet B).
It is easily installed on your 3D Printer following these easy steps:
Remove the backing on Sheet B. Stick this directly to your 3D Printers Heated Bed. Place Sheet A on top. Accurate bed levelling and offset adjustment is important, so you don’t damage your build surface.
Do not use any tape, adhesive sprays, or liquids. Clean your bed regularly by using a mild soapy water solution made with warm water.
Detalles técnicos
| Manufactured mostly in | Europa |
|---|
You may also be interested in
In stock / EU warehouse
In stock / EU warehouse
In stock / EU warehouse
In stock / EU warehouse
Grade Comments (0)